hi hi from my queue two weeks ago sorry I’m late orzz
[General]
[General]
- slider tick seems abnormally loud; in comparison, it’s very hard to hear the slider ends. It’s probably not a big deal, but still, I think it’s worth mentioning
- I think some of your blankets could use more improvement. Some examples include 00:06:735 (2,3) – (uncurve the (2) a little bit), 00:08:265 (1,2) – (uncurve the (1) a little bit), 00:29:079 (2,3) – (move the middle anchor point to the left a bit more), 01:52:641 (4,1) – (the (1) is waaay too curved here), etc. There are more I didn’t list here, so be sure to double check your blankets~
- mm you can put some soft finishes on the cymbal crashes. Examples include 00:02:908 (1) -, 00:05:051 (1) -, 00:06:122 (1) -00:08:265 (1) -, etc. example of what I mean by soft finish can be seen below
- the breaks at 00:35:507 – and 01:34:888 – feel really out of place; why is there a break here? It doesn’t make sense to put a break here. You should probably just map out this part
- the spinners at 00:37:956 (1) – and 01:37:336 (1) – also feel out place; they don’t really make sense with the music. you should just map this part out instead of using a spinner
- 00:49:586 (3,4) – this polarity change might be confusing for beginners. maybe it’s better to make the 3 a reverse slider instead
- the music starts to pick up in intensity again at 01:20:195 (1) -, so I think you should put some circles at 01:22:338 -, 01:24:787 -, and 01:27:235 -. They feel a little empty here
- 02:08:251 (3,1) – I think doing something similar to what you did at 00:09:489 (3,4,1) – fits more than a circle + spinner tbh. Just make the final note a circle instead of a slider~
- 00:03:368 (2,3) – I think reversing the order of these (long slider first, then short slider) works more effectively because then it’s in sync with the guitar
- 02:01:670 (1,2,3,4) – I recommend using a similar pattern to the one I showed you above. It captures the guitar riff more nicely
- 02:08:557 (1) – again I can’t really recommend the spinner because it doesn’t really make sense with the music.
- 00:04:439 (3,4,5) – this looks kind of bad aesthetically. Maybe you can move these around and have them blanket each other. For example:SPOILERin this image I rotated the (4) 15 degrees clockwise from its selection centre. You’re going to have to move the (5) but this way the (3,4) looks nicer
- 00:45:913 (1,3) – move the (3) to x193, y219 so that the slider end is stacked with the (1)
- 00:46:219 (2,4) – move the (4) to x261, y86 so that the slider start is stacked with the (2)
- 00:48:362 (1,2,3,4,5,6,7,8,9) – this is all clumped together and it kind of looks ugly. I’d move the (6) and (7) a little bit farther away from the (4)
- 00:55:708 (1,2,3,4,5,6) – all straight sliders like this seems kind of boring to me. I can’t really recommend this pattern because it feels so monotonous
- 00:59:993 (9,10,1) – why not make this a triangle?
- 01:11:625 (3,4) – I’d move the (4) a bit farther away; it’s touching the edge of (3) and that looks kind of bad, e.g. like it was unintentional
- 01:41:315 (2,3) - ^same; this looks really bad
- 01:43:764 (2,3) - ^same
- 02:08:557 (1) – and again, I don’t really recommend the spinner because it doesn’t really fit with the music